This two in one product (2 in 1) pickling and passivation product quickly and effectively removes chromium oxide, heat tint and discoloration from stainless steel surfaces. Arrives “ Ready to Use” Biodegradable Fume free No negative impact on humans No negative impact on environment.
May be brushed on for flat position treatment.
Highly suitable for repetitive production processes and smaller parts.
When left on stainless steel surfaces it will not cause: pitting, corrosion or discoloration.
Weld Healer replaces traditional and highly dangerous pickling and passivation products which contain hydrofluoric acid.
Weld Healer is unlike traditional hydrofluoric acid-based products which are becoming completely banned or highly regulated in many countries, regions, locations and facilities.
Weld Healer is in total compliance with the highest levels of regulations and is in use in countries, regions, locations and facilities which have banned the use of Hydrofluoric Acid.
Weld Healer achieves desired results without damage to the substrate.
Weld Healer is used effectively on vertical, horizontal and overhead structures.
Fume-free formulation makes it ideal for use: indoor and outdoor applications.
Weld Healer Paste
Product Information
All stainless-steel weld seams
LNG, Natural Gas and Oil industry
Stainless-steel Pipelines
Marine ballast and holding tanks
Storage tanks and vessels
Ocean windmills, Shoreline structures
Boilers and pressure tanks
Architectural
Wineries and Breweries
Speciality applications
Normal working dwell time (In temperatures above freezing) is between 90mins – 120 mins. Dwell time will vary slightly based on the amount of chromium oxide, heat tint and discolouration of the surface. Warmer temperatures increase working speed and decrease dwell time.
We recommend testing in a small area to determine precise Dwell Time.
18-24 lineal metre/litre. Apply at least a 5 cm wide band of Weld Healer product that liberally covers the underlying weld seam and all discoloration.
Colour: Off white
Solubility in water: Miscible
Odour: Slight
Viscosity: 80.00-150.00 CPS
pH: Acidic
Product may be removed by:
Pressure Washing Wiping Washing Nylon/Plastic Scrub brush NEVER use Metal/ Wire brush as cross-contamination will occur. Weld Healer and wash water is fully bio-degradable and may be washed away according to Commonwealth, State or Local Government regulations.
Suitable for application by brushing, spraying or dipping simplifies restorative process. NEVER use a metal bristle brush.
May be applied on vertical, horizontal and overhead structures.
Apply liberally, ensure the surface area to be treated is adequately covered by the Weld Healer product (2mm – 3mm thickness). Once applied DO NOT agitate or interfere with the product. Leave until the desired result is achieved.
Ensure all surfaces are free of loose debris and any liquids or moisture.
Product arrives “Ready for Use”.
DO NOT Dilute with Water.
DO NOT Mix with other products.
Do not apply product in freezing conditions.
Avoid eye contact. Wear chemical safety glasses with side protection.
Avoid skin contact. Use chemical resistant gloves and clothing.
Use in areas with adequate ventilation.
DO NOT swallow or ingest.
DO NOT eat, drink or smoke when using this product.
Wash exposed areas thoroughly with soap and water. Refer to SDS.
Storage:
Ensure unused product is stored in a sealed container to prevent spillage and evaporation.
Avoid extreme hot and cold temperatures when storing.
DO NOT freeze this product.